ODB2 scanner via gprs...A prototype that has the following OBD processor GPS /GPRS....

I need a full device with all the chips in one board. Not using modules.....

A name has to be printed as the PCB is being printed.

This device needs to be mass production ready....

And the mass produced would not be more than $17

So the component selection is important

You make the complete device and send

Go through the hardware and software again

We need a webserver where all the data from the device is seen/storef

You can use

*STN1110*

It's a multiprotocol OBD-II to UART Interpreter IC.

Progettazione di Circuiti Ingegneria Elettrica Elettronica Ingegneria GPS

Rif. progetto: #16540224

Info sul progetto