dc micro grid protection

the project about dc micro grid protection my requirments as follows( i send my simulation works but it is not complete)(DCMGEMAN and fullonformation) 1- impelment the dc ring feeder mg from figure A1(DC MG Architecture considered in this work.) according to table a1 (on last page 181 of file number 1) 2- inject the short circuit line to ground faults on cables of the mg( faults illustrated on figure a1 F1 TO F5) (fault resistance = 0 ,0.2 0.4 0.6 ohm) and get the results and the fault result should be like the simulation result in file number 1 3- from second file (file number 2) the method of differential protection for the mg cables should be applied to the mg impelmented in requirements 1 and 2 4- documentation about details of the simulation and the protection method (full doc) 5-implement the simulation in file three as second simulation which adding PVs to AC MG and get voltage regulation Get attached file in your email.