Power Electronics & Battery Management (BMS) Jobs

I need a complete electrical design for a true-online 600 W UPS that will operate in a home environment. The scope covers everything from the high-level architecture down to production-ready documentation, so that I can have the unit prototyped and assembled without further engineering work. What I expect you to produce includes: • Full schematic with clearly annotated component values • Bill of materials using readily available parts • PCB layout files (Gerber or equivalent) and 3-D board view • Control logic or firmware source (if a microcontroller or DSP is used) • Mechanical outline showing heat-sink placement, transformer or inductor dimensions, and suggested enclosure size • Brief test plan describing how to verify continuous 600 W output, transfer time...

Design review of an industrial data-acquisition system — Stage 1 Safe Instrumentación (SFI), Bogotá, Colombia, designs modular data-acquisition hardware for geotechnical and structural instrumentation installed on bridges, hydroelectric plants and pipelines, at sites up to 4,000 m above sea level. SFI has a bench-validated four-board prototype: a main controller with cellular and sub-GHz radio, isolated RS-485 and native USB; two near-identical sensor front ends, each with its own MCU, for inclination and for a long temperature chain of up to 200 sensors on a shared bus; and a carrier board for a purchased vibrating-wire module with its own high-voltage protection chain. Part numbers are released under NDA. SFI has consolidated that work into a detailed design docume...